LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 1993 >> ES 300 Standard >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Remove/Install/Overhaul >> Ignition System >> Distributor >> Installation (ES300)
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation (ES300)

  1. Ensure No. 1 piston is still at TDC of compression stroke. Install new "O" ring onto distributor housing. Lightly coat "O" ring with oil. Align cut-out marks of distributor coupling and housing. See Fig 1. Install distributor, and lightly tighten hold-down bolts.
  2. Reconnect spark plug, coil wires and distributor connector. Install airflow meter, air cleaner cover and hoses. Start engine and allow to warm up. Check ignition timing. See information in ADJUSTMENTS article. Tighten distributor hold-down bolt to specification. See TORQUE SPECIFICATIONS TABLE  at the end of this article.
Fig 1: Aligning Distributor Housing & Shaft (ES300)
G90B21320Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals