LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 1993 >> SC 300 Standard >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Keyless Entry System >> Circuit Testing >> Ecu Power Source Circuit Test
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Ecu Power Source Circuit Test

  1. When remote door lock main switch is on, battery voltage is applied to terminal No. 1 of remote door lock ECU, causing ECU to operate. See Figure. If ECU does not operate, check DOME fuse and replace as necessary. Gain access to remote door lock ECU. Using a DVOM, measure voltage between ECU terminals No. 1 and 7.
  2. With remote door lock main switch in ON position, 10-14 volts should be present. With remote door lock main switch in OFF position, voltage should not be present. If voltage is as specified, circuit is okay. If voltage is not as specified, check and repair ground circuit as necessary.
  3. If ground circuit is okay, remove instrument panel lower finish panel and remove remote door lock main switch. Disconnect switch connector. Using an ohmmeter, check continuity between switch terminals. With remote door lock main switch in ON position, continuity should exist. With remote door lock main switch in OFF position, continuity should be one megohm or more.
  4. If switch does not test as described, replace main switch. If switch tests as described, check and repair wiring circuit(s) between ECU and main switch, and main switch and battery as necessary.
scientia non olet · About LEMON Manuals