Momentary Interruption Test

If Code 13, 22, 24, 41 or 47 is stored in ECM memory during diagnosis and no trouble can be found with these circuits, perform MOMENTARY INTERRUPTION TEST.

1. Clear codes from ECM memory. See CLEARING CODES . With ignition off, connect a jumper wire between terminals E1 and TE2 of DLCs No. 1 or 2. See Figure.
2. Start engine. Ensure MIL goes out. Pull lightly on wires, and apply vibration to connectors and relays associated with diagnostic code that is set.
3. If MIL illuminates during this test, a fault is in indicated connector or location in wiring harness. Repair as necessary.
4. Clear diagnostic codes. Start engine. If MIL does not go out, check thoroughly for faulty connections. Perform MOMENTARY INTERRUPTION TEST again. If MIL still will not go out, check and replace ECM as necessary. See COMPUTERIZED ENGINE CONTROLS in SYSTEM/COMPONENT TESTS article in the ENGINE PERFORMANCE section.