Toe-In

Fig. 13 Rear Toe-in Measurement:

Fig. 14 Rear Toe-in Adjustment:

1. Measure length of left and right No. 2 lower suspension arm, Fig.13.
2. If difference in length is more than .04 inch, adjust length as follows:
a. Loosen locknuts, ten turn left and right adjusting tube an equal amount to adjust toe-in, Fig. 14.
b. One turn of adjusting tube will adjust toe-in approximately .264 inches.
c. Following adjustment, torque locknuts to 41 ft. lbs.