Cruise Control Switch Test
- Disconnect cruise control switch 6-pin connector. Connector is located underneath steering wheel. Check for continuity between Brown wire and Yellow/Red wire of 6-pin connector. With cruise ON-OFF switch off, continuity should not exist. With cruise ON-OFF switch on, continuity should exist. If continuity is as specified, go to next step. If continuity is not as specified, replace switch.
- With control switch is specified position, measure resistance between Brown wire and Black/Green wire of 6-pin connector. See TESTING CRUISE CONTROL SWITCH table. If resistance is as specified, switch is okay. If resistance is not as specified, replace switch.
TESTING CRUISE CONTROL SWITCH
| Control Switch Position |
Ohms |
| OFF |
Infinite |
| RESUME/ACCEL |
68 |
| SET/COAST |
198 |
| CANCEL |
418 |