LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 1997 >> LS 400 >> Repair and Diagnosis >> Steering >> Steering Column >> Steering Columns - Power Tilt System >> Testing >> Tilt & Telescopic Control Module Power Supply Circuit >> Without Memory
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Without Memory

  1. Remove tilt and telescopic control module. With ignition off, measure voltage between tilt and telescopic control module connector T9, terminals No. 7 and No. 18. See Figure and Figure . If voltage is not 10-16 volts, go to next step. If voltage is 10-16 volts, go to TROUBLE SHOOTING  and identify next circuit to be checked.
  2. Measure resistance between tilt and telescopic control module connector T9, terminal No. 7 and ground. If resistance is less than one ohm, go to next step. If resistance is not less than one ohm, repair open in White/Black wire between control module connector T9, terminal No. 7 and ground. See WIRING DIAGRAMS .
  3. Check 10 amp SEC HORN fuse. If fuse is okay, check for open in White/Blue wire between tilt and telescopic control module connector T10, terminal No. 20 and fuse block. See WIRING DIAGRAMS . If fuse is blown, check and repair short Blue/Yellow wire between tilt and telescopic control module connector T10, terminal No. 20 and fuse block.
scientia non olet · About LEMON Manuals