Integration Relay Circuit
Remove integration relay from instrument panel junction block. Check for continuity or voltage between ground and specified terminals. See INTEGRATION RELAY CIRCUIT TEST table. See Figure. If values are as specified, replace relay. If values are not as specified, check and repair wiring harness as necessary. See WIRING DIAGRAMS .
INTEGRATION RELAY CIRCUIT TEST
| Terminal No. (1) | Condition | Value | ||
|---|---|---|---|---|
| 8 | Driver's Belt Disconnected | No Continuity | ||
| Driver's Belt Connected | Continuity | |||
| 10 | Always | Continuity | ||
| 7 Or 9 | Ignition In Lock Or ACC | No Voltage | ||
| Ignition On | Battery Voltage | |||
|
||||