Relearn Procedure
NOTE:
If battery was disconnected, power window control system and sun roof may need to be initialized for proper operation by performing relearn procedure.
- To re-initialize power window control system, close any window to highest position and hold window control switch in this position for 5 seconds. Check that power window automatic operation works properly. If power window automatic operation does not operate properly, repeat procedure.
- To re-initialize sun roof, depress sun roof switch and operate sun roof to maximum tilt position. Release sun roof switch.
- Depress and hold sun roof switch again. After 10 seconds, sun roof will start automatic operation and complete one cycle (tilt downward, slide open, slide closed and tilt upward) while sun roof switch is depressed. DO NOT release sun roof switch until sun roof stops. Check that sun roof stops in correct position.