Vehicle Access Code Programming
NOTE:
Ensure key is not in ignition switch. Open and unlock driver's door. Close and lock other doors. Add mode adds an additional transmitter. Rewrite mode rewrites a transmitter.
- Perform this step in 40 seconds or less: Insert key in ignition switch, then pull out. Press door lock control switch 5 times to LOCK/UNLOCK at about one-second intervals. Close driver's door. Open driver's door.
- Perform this step in 40 seconds or less: Press door lock control switch 5 times to LOCK/UNLOCK at about one-second intervals. Insert key in ignition switch. To put system in add mode, turn ignition switch from ON to LOCK positions one time at about one-second intervals. To put system in rewrite mode, turn ignition switch from ON to LOCK positions 2 times at about one-second intervals. Remove key from ignition switch.
- This step will be performed in 3 seconds or less: MPX body ECU automatically performs LOCK/UNLOCK operation once at one-second intervals to inform operator that add mode has been selected. MPX body ECU automatically performs LOCK/UNLOCK operation twice at one-second intervals to inform operator that rewrite mode has been selected.
- Within 20 seconds, press any one of 3 transmitter buttons for more than one second. MPX body ECU automatically performs LOCK/UNLOCK operation 1-2 times at one-second intervals to inform operator that it has received signal from transmitter. If LOCK/UNLOCK occurs once, registration of recognition code is completed. If LOCK/UNLOCK occurs twice, registration of recognition code was not completed. Repeat programming procedure.
- After programming is completed, registration of recognition code is completed 20 seconds after MPX body ECU response, driver's door is closed, key is inserted in ignition switch, or 4 types of recognition codes are registered at one time.