PCM (Customer Supplied Only One Valid Key)
- Cut new transponder equipped key(s), if necessary. Replace PCM. Using new 1st key, turn ignition to ON position. SECURITY light should illuminate for 1-2 seconds. Turn new 1st key to LOCK position.
- Using new 2nd key, turn ignition to ON position, then LOCK position 6 times. Ensure 6th turning is done within one second. SECURITY light should be flashing at a 300 millisecond interval. Wait about 5 minutes until SECURITY light flashing has decreased to a 1.2 second interval.
- Input code word. See INPUTTING CODE WORD. SECURITY light should stop flashing and stay illuminated. Using new 2nd key, turn ignition to ON position. SECURITY light should illuminate for 1-2 seconds. Turn new 2nd key to LOCK position and remove key.
- Using valid key, start engine. SECURITY light should illuminate for 1-2 seconds and engine should continue to run. Turn valid key to LOCK position and remove key.
- Repeat step 4) with each new key, up to 8 keys total. Wait 30 seconds, program will quit automatically. After reprogramming is complete, clear DTCs with New Generation Star (NGS) tester.
NOTE:
Keys may be new or valid. If errors occur during reprogramming in steps 1) or 2), start over from step 1). If errors occur during step 3), go to REPROGRAM ERROR RECOVERY.