Camshaft Position Sensor
Remove engine cover. Locate Camshaft Position (CMP) sensor. See CAMSHAFT POSITION SENSOR LOCATION table. Remove intake air connector pipe, if necessary. Disconnect CMP sensor 2-pin connector. Measure resistance between CMP sensor terminals. Replace CMP sensor if resistance is not as specified. See CAMSHAFT POSITION SENSOR RESISTANCE table.
CAMSHAFT POSITION SENSOR LOCATION
| Application | Location |
|---|---|
| GS300 & SC300 | Left Rear Intake Side Of Cylinder Head |
| GS400, LS400 & SC400 | Mounted To Front Of Left Upper (No. 3) Timing Belt Cover |
CAMSHAFT POSITION SENSOR RESISTANCE
| Temperature °F (°C) | Ohms |
|---|---|
| -14-122 (-10-50) | 835-1400 |
| 123-212 (51-100) | 1060-1645 |