Master Cylinder Push Rod
- Install Adjusting Gauge (09737-00010) on master cylinder with master cylinder gasket in place. Lower adjusting gauge pin until pin slightly touches master cylinder piston. Perform STEP 1 in illustration. See Fig 1. Turn adjusting gauge upside down and install on power brake unit. Perform STEP 2 in illustration. See Fig 1.
- Install power brake unit and measure clearance between power brake unit push rod and adjusting gauge pin head. Measured clearance should be zero. If clearance is not zero, adjust master cylinder push rod length until push rod lightly touches adjusting gauge pin head. When adjusting push rod, depress brake pedal.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002