LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2000 >> SC 400 >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Self-Diagnostics >> Diagnostic Tests >> DTC P1120: Accelerator Position Sensor Circuit Malfunction >> Diagnosis & Repair (Using OBD-II Scan Tool)
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnosis & Repair (Using OBD-II Scan Tool)

  1. Turn ignition on. Backprobing, measure voltage between terminals No. 2 (Blue/Black wire) and No. 18 (Brown wire) at ECM E16 connector. See Figure. If voltage is 4.5-5.5 volts, go to next step. If voltage is not 4.5-5.5 volts, replace ECM and retest.
  2. Turn ignition on. Backprobing, measure voltage between terminals No. 18 (Brown wire) and No. 21 (Yellow/Red wire) at ECM E16 connector. With fully closed throttle, voltage should be .3-.9 volt. With Wide Open Throttle (WOT), voltage should be 3.2-4.8 volts. Measure voltage between terminals No. 18 (Brown wire) and No. 9 (Red/Blue wire) at ECM E16 connector. With fully closed throttle, voltage should be 1.8-2.7 volts. With WOT, voltage should be 4.7-5.1 volts. If voltage is not as specified, go to next step. If voltage is as specified, replace ECM and retest.
  3. Check accelerator pedal sensor operation. See ENGINE SENSORS & SWITCHES in appropriate SYSTEM & COMPONENT TESTING article. Replace accelerator pedal sensor as necessary. If accelerator pedal sensor is okay, check for short or open circuit in wiring harness and sensor connector between ECM E16 connector and accelerator pedal sensor. See appropriate wiring diagram in WIRING DIAGRAMS article. Repair wiring as necessary.
scientia non olet · About LEMON Manuals