Front Doors
- Remove door trim panel and service hole cover. Disconnect 6-pin electrical connector from door lock motor. Connect ohmmeter between the following door lock motor connector (component side) terminals. See WIRING DIAGRAMS .
- Left front door motor; terminals No. 3 (Brown/Black wire) and No. 4 (Gray wire).
- Right front door motor; terminals No. 3 (Green wire) and No. 4 (Brown/Black wire).
- When door is locked, continuity should not exist. When door is unlocked, continuity should exist. If continuity is not as specified, replace door unlock detection switch and retest system operation.