Rear Doors
- Remove door trim panel and service hole cover. Disconnect 4-pin electrical connector from door lock motor. Connect ohmmeter between the following door lock motor connector (component side) terminals. See WIRING DIAGRAMS .
- Left rear door motor; terminals No. 3 (Green wire) and No. 4 (Brown/Black wire).
- Right rear door motor; terminals No. 1 (Brown/Black wire) and No. 2 (Green wire).
- When door is locked, continuity should not exist. When door is unlocked, continuity should exist. If continuity is not as specified, replace door unlock detection switch and retest system operation.