Jam Protection Limit Switch (Front)
WARNING: This page is about a different car, the 2002 Lexus GS 430 and 2002 Lexus GS 300. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
If connecting the wire harness wrongly, the sensor might be damaged so caution is necessary.
- Inspect the jam protection limit switch operation with the window up.
- Connect the positive (+) lead from the ohmmeter to terminal No. 4 and the negative (-) lead to terminal No. 5. See CONNECTOR IDENTIFICATION .
- On the driver's door, connect the positive (+) lead from the battery to terminal No. 1 and the negative (-) lead to terminal No. 2.
- On the passenger's door, connect the positive (+) lead from the battery to terminal No. 2 and the negative (-) lead to terminal No. 1.
- Check that the continuity exists when the window goes up.
- Check that no continuity exists when the window is in the fully closed position.
- If the operation is not as specified, replace the motor. See FRONT DOOR POWER WINDOW REGULATOR under COMPONENT TESTS.