Power Window Motor Limit Switch

Remove power window motor. Place matchmarks on power window motor and window regulator gear. Connect motor to vehicle harness. Rotate motor 6-10 turns or 4-5 seconds in upward window direction. This sets limit switch to OFF position (TDC of window glass). Reassemble power window motor and regulator. Install motor when regulator arm is below midpoint. Align matchmarks on power window motor and window regulator gear. Reassemble power window regulator and glass.
NOTE: Do not rotate motor to down position before window glass is installed.
Reconnect power window switch connector. Turn ignition on. Repeat up and down operation several times manually. Check if AUTO UP to AUTO DOWN operates in automatic operation. Ensure jam protection function does not operate just after resetting. Reset regulator again when performing reverse operation after closing window fully with AUTO UP operation. Check power window function.