Optical Sensor: Installation
WARNING: This page is about a different car, the 2004 Chrysler Pacifica. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Be certain the optical sensor wires are reinstalled in the correct wire cavities. Failure to do so could result in damage to components. Refer to CONNECTOR PIN-OUTS
if previous notes were not made.
- Perform a wiring repair on the optical sensor wires, or install new terminals on the wire ends and reinstall in the drive unit electrical connector. Be certain to follow the approved procedure in SYSTEM WIRING DIAGRAMS .
- Install the optical sensor on the clutch housing assembly:
- Connect the negative battery cable.
- Using an appropriate scan tool, check any erase any power liftgate control module diagnostic trouble codes.
- Verify power liftgate system and optical sensor operation. Cycle the power liftgate through one complete open and close cycle, this will allow the power liftgate control module to relearn its cycle with the new components.
- Install the left rear D-pillar trim panel on the vehicle. Refer to D-PILLAR TRIM .