LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2003 >> ES 300 >> Repair and Diagnosis >> External Pages >> Different car >> Section 427 (Power Liftgate System) >> Pinch Sensor >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Pinch Sensor: Installation

WARNING: This page is about a different car, the 2004 Chrysler Pacifica. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the pinch sensor and install screws holding the sensor to the liftgate, third one down first. Torque screws to 25 in. lbs.
  2. Install wire harness grommet in liftgate flange and route, connect the pinch sensor wire harness connector.
  3. Install the trim panel on the liftgate. Refer to LIFTGATE .
  4. Connect the negative battery cable.
  5. Using an appropriate scan tool, check and erase any power liftgate control module diagnostic trouble codes related to the pinch sensor.
  6. Verify power liftgate system and pinch sensor operation. Cycle the power liftgate through one complete open and close cycle, during the final close cycle press the pinch sensor to verify the power liftgate detects an obstruction and returns to the full open position.
    WARNING: USE EXTREME CAUTION WHEN TESTING PINCH SENSOR OPERATION. PERSONAL INJURY MAY RESULT.
scientia non olet · About LEMON Manuals