Driver's Door (Window Up):

INSPECT JAM PROTECTION LIMIT SWITCH OPERATION

Connect the positive (+) lead from the ohmmeter to terminal 4 and the negative (-) lead to terminal 5.
Connect the positive (+) lead from the battery to terminal 1 and the negative (-) lead to terminal 2.
Check that the continuity exists when the window goes up.

Fig 1: Inspecting Jam Protection Limit Switch Operation (Driver'S Door - Window Up) (1 Of 2)
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Check that the no continuity exists when the window is in the fully closed position.

Fig 2: Inspecting Jam Protection Limit Switch Operation (Driver'S Door - Window Up) (2 Of 2)

If operation is not as specified, replace the motor.

NOTE: If connecting the wire harness wrongly, the sensor might be damaged so caution is necessary.