LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2003 >> IS 300 Base, Standard >> Repair and Diagnosis >> Body & Frame >> Windows >> Power Windows >> Adjustments >> Power Window Motor (Limit Switch & Pulse Switch) Reset
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Power Window Motor (Limit Switch & Pulse Switch) Reset

NOTE: It is necessary to reset the power window motor (in initial position for the limit switch) when separating the window regulator from the power window motor or operating with the door glass not installed.
    NOTE: Place the matchmarks on the power window motor and window regulator gear.
  1. Remove the power window motor. See POWER WINDOW REGULATOR MOTOR (FRONT)  or POWER WINDOW REGULATOR MOTOR (REAR)  under REMOVAL & INSTALLATION.
  2. Connect the power window motor and power window switch to wiring harness of the vehicle.
  3. Turn the ignition switch ON and operate the power window switch to idle the power window motor in UP side direction for more than 6 rotations or less than 10 rotations (4 seconds or more).
  4. Assemble the power window motor and regulator.
    • Install the motor when the regulator arm is below the middle point.
    • Align the matchmarks on the power window motor and window regulator gear.
    5. CAUTION: Never rotate the motor to the down direction until the completion of the window glass installation.
  5. Assemble the power window regulator and door glass.
  6. Connect the power window switch to the wiring harness and turn the ignition switch ON.
  7. Repeat UP and DOWN operation several times manually.
    8. NOTE: Take care that the jam protection function does not operate just after resetting. Reset the regulator again when performing the reverse operating after closing the window fully by AUTO UP operation.
  8. Check if AUTO UP to AUTO DOWN operates in automatic operation.
  9. Check the power window function.
scientia non olet · About LEMON Manuals