LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2003 >> IS 300 Base, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Self-Diagnostics >> Self-Diagnostic System >> Retrieving Diagnostic Trouble Codes >> CHECK Mode Code Retrieval (Lexus Scan Tool Only)
April 5, 2026: LEMON Manuals is launched! Read the announcement.

CHECK Mode Code Retrieval (Lexus Scan Tool Only)

  1. Ensure vehicle battery is fully charged (at least 11 volts). Shift transmission/transaxle into Neutral (M/T) or Park (A/T). Turn A/C and all accessories off. Ensure throttle is in idle position.
  2. Turn ignition off. Connect scan tool to Data Link Connector (DLC) No. 3. See Figure. DLC No. 3 connector is located under left side of instrument panel. Turn ignition on with engine off. Turn scan tool on.
  3. Switch scan tool from NORMAL mode to CHECK mode. CHECK mode is operational if MIL on instrument cluster flashes. Start engine. Ensure MIL goes off. Try to simulate conditions of driveability complaint described by customer.
    NOTE: If ignition is turned from ON to ACC or OFF position, all DTCs and freeze-frame data will be erased. DO NOT switch modes or turn ignition off until all DTCs and freeze-frame data are recorded.
  4. Record any DTCs and freeze-frame data displayed for system diagnosis. If driveability problem exists and no codes are present, go to TROUBLE SHOOTING - NO CODES article for diagnosis by symptom.
  5. If any DTCs are present, perform appropriate diagnostic test. See DIAGNOSTIC TROUBLE CODE DEFINITIONS . For more information on freeze-frame data, see FREEZE-FRAME DATA  under INTRODUCTION. For information on 2-trip detection logic codes, see TWO-TRIP DETECTION LOGIC  under DETECTION LOGIC under INTRODUCTION.
  6. After repairs for DTC have been completed, DTC must be cleared from ECM memory. See CLEARING DIAGNOSTIC TROUBLE CODES .
scientia non olet · About LEMON Manuals