Test K: VSC Sensor Signal Check: Notes

WARNING: This page is about a different car, the 2004 Lexus SC 430, 2003 Lexus SC 430, and 2002 Lexus SC 430. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: If the yaw rate sensor, deceleration sensor and/or ECU have been replaced, perform zero point calibration of the yaw rate sensor and deceleration sensors before performing this procedure. See PROGRAMMING .

NOTE: If the ignition switch turned from ON to ACC or LOCK during test mode, DTC will be erased.