Erasure Of Transponder Key Code (Except PRIUS): Sequoia
WARNING: This page does not describe the selected car, but rather 17 other vehicles, including the 2003 Toyota Tundra, 2003 Toyota Tacoma, 2003 Toyota Sienna, 2003 Toyota Sequoia, and 2003 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Delete all other master and sub-key codes leaving the master key code to use operation. When using key which was used before deletion, it is necessary to register the code again.
NOTE:
When any operation time described in following procedures is over, registration mode completes. When next procedure is performed while timer is working, the timer completes counting time and then the next timer starts.
- Ensure all doors are closed and that key is not in ignition lock cylinder.
- Insert registered master key in ignition lock cylinder. Within 15 seconds of inserting master key into ignition lock cylinder, turn ignition switch from LOCK position to ON position 6 times.
- With completion of ignition operation, open and close driver side door 7 times within 20 seconds.
- Upon completion of closing driver side door for final time, remove registered master key.