Starter Specifications
WARNING: This page is about a different car, the 2004 Toyota 4Runner and 2003 Toyota 4Runner. However, it is still accessible from the selected car via links, so may be relevant.
STARTER SPECIFICATIONS (1.4 Kw)
| Application | In. (mm) | ||
|---|---|---|---|
| Brush Length | |||
| Standard | .610 (15.5) | ||
| Minimum | .394 (10) | ||
| Commutator | |||
| Diameter | |||
| Minimum | 1.142 (29) | ||
| Standard | 1.181 (30) | ||
| Runout | .0020 (.05) | ||
| Undercut Depth | |||
| Standard | .024 (.6) | ||
| Minimum | .008 (.2) | ||
| Spring Load | |||
| Installed Minimum | 2.7 Lb. (1.2 Kg.) | ||
| Installed Standard | 4.0-5.3 Lb. (1.79-2.41 Kg.) | ||
STARTER SPECIFICATIONS (1.6 Kw)
| Application | In (mm) | ||
|---|---|---|---|
| Brush Holder Length | |||
| Standard | .354 (9.0) | ||
| Minimum | .157 (4.0) | ||
| Commutator | |||
| Length | |||
| Standard | .122 (3.1) | ||
| Maximum | .150 (3.8) | ||
| Runout | .002 (.05) | ||
| Snap Ring End Gap | .197 (5.0) | ||
STARTER SPECIFICATIONS (2 Kw)
| Application | In. (mm) | ||
|---|---|---|---|
| Brush Length | |||
| Standard | .591 (15) | ||
| Minimum | .354 (9) | ||
| Commutator | |||
| Diameter | |||
| Minimum | 1.339 (34) | ||
| Standard | 1.378 (35) | ||
| Runout | .0020 (.05) | ||
| Undercut Depth | |||
| Standard | .028 (.7) | ||
| Minimum | .008 (.2) | ||
| Shunt Coil Resistance | 1.5-1.9Ω at (68° F) (20° C) | ||
| Spring Load | |||
| Installed Minimum | 2.7 Lb. (1.2 Kg.) | ||
| Installed Standard | 4.8-6.2 Lb. (2.2-2.8 Kg.) | ||