Height Control Sensor Sub-ASSY Rear LH: Replacement

WARNING: This page is about a different car, the 2004 Lexus LS 430. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.

REMOVE HEIGHT CONTROL SENSOR SUB-ASSY REAR LH
1. Disconnect the connector.
2. Place matchmarks on the height control sensor link and bracket.
3. Remove the nut and disconnect the height control sensor link.
  
  Fig 1: Removing Nut And Disconnect Height Control Sensor Link
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Remove the 2 bolts and height control sensor sub-assy rear LH.
  
  Fig 2: Removing Bolts And Height Control Sensor Sub-Assy Rear LH
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL HEIGHT CONTROL SENSOR SUB-ASSY REAR LH
1. Install the height control sensor sub-assy rear LH with 2 bolts.
  Torque: 7.8 N.m (80 kgf.cm, 69 in. lbf)
  
  Fig 3: Installing Height Control Sensor Sub-Assy Rear LH
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Align the matchmarks on the height control sensor link and bracket.
3. Install the nut.
  Torque: 5.4 N.m (55 kgf.cm, 48 in. lbf)
4. Connect the connector.
  
  Fig 4: Aligning Matchmarks On Height Control Sensor Link And Bracket
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
ADJUST VEHICLE HEIGHT (SEE ON-VEHICLE INSPECTION )