Height Control Valve Sub-ASSY No.2: Replacement

WARNING: This page is about a different car, the 2004 Lexus LS 430. However, it is still accessible from the selected car via links, so may be relevant.

REMOVE HEIGHT CONTROL VALVE SUB-ASSY NO.2
1. Disconnect the connector.
2. Disconnect the 3 air tubes (see PRECAUTION ).
3. Remove the 2 nuts and height control valve sub-assy No.2.
  
  Fig 1: Removing Nuts And Height Control Valve Sub-Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL HEIGHT CONTROL VALVE SUB-ASSY NO.2
1. Install the height control valve sub-assy No.2 with 2 nuts.
  Torque: 5.4 N.m (55 kgf.cm, 48 in. lbf)
2. Connect the 3 air tubes (see PRECAUTION ).
3. Connect the connector.
  
  Fig 2: Installing Height Control Valve Sub-Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSPECT AIR LEAK (SEE ON-VEHICLE INSPECTION