Window Down
CAUTION:
Sensor may be damaged if wiring harness is connected incorrectly.
- Connect the positive (+) lead from the ohmmeter to terminal No. 2 and the negative (-) lead to terminal No. 6. See CONNECTOR IDENTIFICATION .
- Connect the positive (+) lead from the battery to terminal No. 1 and the negative (-) lead to terminal No. 3.
- Check that the continuity exists when the window goes down.
- Check that no continuity exists when the window is in the fully opened position. If operation is not as specified, replace the motor. See WINDOW REGULATOR (REAR DOOR) under REMOVAL & INSTALLATION.