DTC P0340, DTC P0341, DTC P0345 Or DTC P0346: Notes
Code Definition
- DTC P0340: Camshaft Position Sensor "A" Circuit (Bank 1 Or Single Sensor)
- DTC P0341: Camshaft Position Sensor "A" Circuit Range/Performance (Bank 1 Or Single Sensor)
- DTC P0345: Camshaft Position Sensor "A" Circuit (Bank 2)
- DTC P0346: Camshaft Position Sensor "A" Circuit Range/Performance (Bank 2)
NOTE:
For information on engine immobilizer system, see COMPUTERIZED ENGINE CONTROLS
in THEORY & OPERATION article.
CAUTION:
If ECM replacement is instructed in following testing, always ensure ECM harness connector and ground circuit are okay. If either are suspect, repair and repeat testing to confirm ECM malfunction. If ECM is replaced, ECM must be programmed with proper ignition key code for engine immobilizer system. For programming procedures, see COMPUTER RELEARN PROCEDURES - LEXUS
article.