Deceleration Sensor Zero Point Calibration

WARNING: This page is about a different car, the 2002 Lexus LX 470 and 2001 Lexus LX 470. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Perform zero point calibration of yaw rate sensor first. See YAW RATE SENSOR ZERO POINT CALIBRATION .

Using special tool (09843-18020), jumper between terminals Ts and E₁ of (DLC1). See Fig 1.
Turn ignition switch on. Ensure vehicle is in a stationary condition with shift lever in Park position.
Check that VSC warning light is lit for about 4 seconds and then starts flashing at .13 second intervals.
After confirming flashing of VSC warning light for 2 seconds, turn ignition switch off.
Remove special tool.

Fig 1: Identifying Ts Connection Of (DLC1)