Inspection Procedure

1. Using the hand-held tester, check operation of the master switch using the DATA LIST.

Standard: 

DATA LIST in D-DOOR ECU 

1. NG: Go to step   3 . 
2. OK: Go to next step. 

1. Disconnect the D18 master switch connector.
2. Remove the front door trim LH.
3. Disconnect the P10 power window motor connector.
4. Check the continuity between the wire harness side connectors.

   Standard: 

   MASTER SWITCH TO MOTOR CONTINUITY
   
   

   Terminal No.	Specified Condition
   D18-11 <==> P10-1	Continuity
   D18-1 <==> P10-2	Continuity
   D18-1 <==> Body ground	No continuity
   D18-11 <==> Body ground	No continuity

   Fig 1: Identifying Terminals Of Power Window Master Switch & Power Window Motor Connectors

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Reference:

   Check operation of the power window motor (driver side).

   1. Remove the motor (See OVERHAUL ).
   2. Apply battery voltage to the connector between terminals 1 and 2.
   3. Check that the motor rotates smoothly.
      Fig 2: Checking Power Window Motor Operation (Driver's Side)

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE: Do not apply battery voltage to the terminals except 1 and 2.

      Standard: 

      Fig 3: Power Window Motor (Driver Side) Operation Table

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. NG: REPAIR OR REPLACE HARNESS AND CONNECTOR 
2. OK: REPLACE POWER WINDOW REGULATOR MOTOR ASSY LH (DRIVER SIDE) 

1. Remove the master switch (the connector is connected).
2. Check the continuity between terminal 2 and the body ground.

   Standard: Continuity 

   Fig 4: Identifying Terminals Of Power Window Regulator Master Switch Assy Connector

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. NG: REPAIR OR REPLACE HARNESS AND CONNECTOR 
2. OK: Go to next step. 

1. Check the voltage between the terminals.

   Standard: 

   POWER WINDOW REGULATOR MASTER SWITCH ASSY (FOR POWER SOURCE) SPECIFIED CONDITION
   
   

   Terminal No.	Condition	Specified Condition
   9 <==> 2	Constant	10 - 14 V
   20 <==> 2	Ignition ON	10 - 14 V
   10 <==> 2	Constant	10 - 14 V

   Fig 5: Identifying Terminals Of Power Window Regulator Master Switch Assy Connector (For Power Source)

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. NG: repair OR replace harness and connector (power source circuit) 
2. OK: REPLACE POWER WINDOW REGULATOR MASTER SWITCH ASSY