Height Control Reservoir ASSY: Replacement

HINT:

See COMPONENTS 

1. DISCONNECT HEIGHT CONTROL TUBE NO. 2 
   1. Remove the holder.
   2. Spread the clip and slowly pull the height control tube No. 2 straight out.
   3. Remove the 2 O-rings.
2. DISCONNECT HEIGHT CONTROL TUBE NO. 6 
   1. Using SST, disconnect the height control tube No. 6.

      SST 09730-00010

      NOTE: Refer to PRECAUTION of removal and installation of the height control tube (See PRECAUTION  ).
   2. Remove the 2 O-rings, the plate and the connector No. 2.
3. DISCONNECT HEIGHT CONTROL TUBE NO. 7 
   1. Using SST, disconnect the height control tube No. 7.

      SST 09730-00010

      NOTE: Refer to PRECAUTION of removal and installation of the height control tube (See PRECAUTION  ).
   2. Remove the 2 O-rings, the plate and the connector No. 2.
4. REMOVE HEIGHT CONTROL RESERVOIR ASSY 
   1. Remove the 2 bolts and the height control reservoir assy.
5. INSTALL HEIGHT CONTROL RESERVOIR ASSY 
   1. Install the height control reservoir assy with the 2 bolts.

      Torque: 29 N.m (300 kgf.cm, 21 ft.lbf) 

6. CONNECT HEIGHT CONTROL TUBE NO.7 
   1. Install 2 new O-rings, a new plate, a new connector No. 2, and connect the height control tube No. 7.
      NOTE: Refer to PRECAUTION of removal and installation of the height control tube (See PRECAUTION  ).
7. CONNECT HEIGHT CONTROL TUBE NO. 6 
   1. Install 2 new O-rings, a new plate, a new connector No. 2, and connect the height control tube No. 6.
      NOTE: Refer to PRECAUTION of removal and installation of the height control tube (See PRECAUTION  ).
8. CONNECT HEIGHT CONTROL TUBE NO. 2 
   1. Coat 2 new O-rings with MP grease.
   2. Push the height control tube No. 2 in straight to connect it until the clip makes "click" sound.
   3. Install the holder.
9. INSPECT AIR LEAK (See  ON-VEHICLE INSPECTION   )