Inspection Procedure

HINT:

In case of using the hand-held tester, start the inspection from step 1 and in case of not using the hand-held tester, start from step  2.

1. Check driver buckle switch using hand-held tester. 

   PREPARATION: 

   Connect the hand-held tester to the DLC 3.

   CHECK: 

   Check the driver buckle switch using DATA LIST.

   OK: Proceed to next circuit inspection shown on problem symptoms table. (See  PROBLEM SYMPTOMS TABLE  ) 

   NG: Go to next step 

2. Check driver buckle switch (See  INSPECTION  ). 

   NG: Replace the driver buckle switch. 

   OK: Go to next step 

3. Check wire harness and connector between driver buckle switch and body ground. 

   NG: Repair or replace wire harness or connector. 

   OK: Proceed to next circuit inspection shown on problem symptoms table. (See  PROBLEM SYMPTOMS TABLE  )