Instrument Panel: Disassembly

Remove the screw, then disconnect the side defroster duct as shown in the illustration.

Remove the screw and side defroster nozzle duct.

Remove the 3 screws and defroster nozzle assembly.

Remove the 3 screws and heater to register duct.

Fig 1: Removing No. 1 Heater To Register Duct

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Remove the 2 screws and center bracket.
2. Remove the 2 screws and heater to register duct.
   Fig 2: Removing No. 2 Heater To Register Duct

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Remove the screw and register as shown in the illustration.

Fig 3: Removing No. 1 & No. 2 Register

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Disconnect the connectors.
2. Disengage the wire harness clamps and remove the instrument panel wire.
Fig 4: Removing No. 2 Instrument Panel Wire
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Using a screwdriver, disengage the 5 claws and remove the instrument side panel.

HINT:

Tape the screwdriver tip before use.

Fig 5: Removing Instrument Side Panel

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Remove the 4 screws and pins.

1. Using a heat light, heat the end pad between 20 to 30°C (68 to 86°F).
   NOTE: Do not heat the end pad excessively. 
2. Remove the end pad.

HINT:

When replacing the end pad, use a new pad.