Torque Specification
STEERING TORQUE SPECIFICATION
| Part tightened | N.m | kgf.cm | ft.lbf |
|---|---|---|---|
| TILT STEERING COLUMN | |||
| Tilt steering shaft | 20 | 210 | 15 |
| Turn signal bracket set bolt | 2.9 | 30 | 26 in.lbf |
| Column protector set bolt | 6.1 | 60 | 52 in.lbf |
| Column tube support x Column tube | 15 | 150 | 11 |
| No. 2 intermediate shaft assembly x Main shaft assembly | 35 | 360 | 26 |
| Steering column assembly set nut | 26 | 270 | 19 |
| Sliding yoke x No. 2 intermediate shaft assembly | 35 | 360 | 26 |
| Sliding yoke x Control valve shaft | 35 | 360 | 26 |
| Steering wheel set nut | 50 | 510 | 37 |
| Steering wheel pad set screw (Torx screw) | 8.8 | 90 | 78 in.lbf |
| POWER STEERING VANE PUMP | |||
| Rear housing | 24 | 240 | 17 |
| Pressure port union | 83 | 850 | 61 |
| Oil reservoir Front side | 13 | 130 | 9 |
| Rear side | 24 | 240 | 17 |
| Vane pump pulley set nut | 44 | 450 | 33 |
| Vane pump assembly set bolt | 58 | 590 | 43 |
| Pressure feed tube x PS vane pump assembly | 49 | 500 | 36 |
| POWER STEERING GEAR | |||
| Cylinder end stopper | 59 | 600 | 44 |
| Bearing guide nut | 25 | 250 | 18 |
| Control valve housing x Rack housing | 18 | 180 | 13 |
| Rack guide spring cap lock nut | 50 (69) | 510 (700) | 37 (51) |
| Rack x Rack end | 76 (103) | 780 (1, 050) | 56 (76) |
| Tie rod end lock nut | 56 | 570 | 41 |
| Turn pressure tube union nut | 22 (25) | 220 (250) | 16 (18) |
| PS gear assembly set bolt | 74 | 750 | 54 |
| Return tube x PS gear assembly | 40 (44) | 410 (450) | 30 (33) |
| Pressure feed tube x PS gear assembly | 42 | 430 | 31 |
| Front suspension member brace Bolt A | 119 | 1, 210 | 88 |
| Bolt B | 58 | 590 | 43 |
| Sliding yoke x Control valve shaft | 35 | 360 | 26 |
| Tie rod end x Steering knuckle | 54 | 550 | 40 |
| Front brake caliper x Steering knuckle | 118 | 1, 200 | 87 |
| Steering wheel set nut | 50 | 510 | 37 |
| (): For use without SST | |||