Steering Pad Switch: Installation

WARNING: This page is about a different car, the 2008 Lexus RX 350. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL STEERING PAD SWITCH ASSEMBLY
1. Engage the 2 claws and the pin.
2. Install the steering pad switch RH with the screw.
  
  Fig 1: Identifying Claws & Pin On Steering Pad Switch RH
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Engage the 2 claws and the pin.
4. Install the steering pad switch LH with the screw.
  
  Fig 2: Identifying Claws & Pin On Steering Pad Switch LH
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Connect each connector.
INSTALL STEERING PAD (See extxref document="A00312388" filetype="sgml" extrefid="S22725104562009041400000">INSTALLATION )
INSTALL LOWER NO.3 STEERING WHEEL COVER (See extxref document="A00312388" filetype="sgml" extrefid="S22725104562009041400000">INSTALLATION )
INSTALL LOWER NO.2 STEERING WHEEL COVER (See extxref document="A00312388" filetype="sgml" extrefid="S22725104562009041400000">INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
PERFORM INITIALIZATION
NOTE: Some systems need initialization when disconnecting the cable from the negative battery terminal. (See INITIALIZATION )
INSPECT STEERING PAD
(See ON-VEHICLE INSPECTION ).
INSPECT SRS WARNING LIGHT
(See DIAGNOSIS SYSTEM )