Inspection Procedure
- RESET POWER WINDOW REGULATOR MOTOR
- Reset the power window regulator motor for the power window that does not fully close (Refer to the pre-check, step 16)
.
- Check if the power window operates normally.
- NG: Go to step 2.
- OK: END
- CHECK POWER WINDOW REGULATOR W/MOTOR
- Remove the door glass (See OVERHAUL
for front doors), (See OVERHAUL
for rear doors).
- Operate the power window regulator without the door glass using the power window switch.
- Check that the power window regulator operates smoothly.
- NG: REPLACE DOOR WINDOW REGULATOR
- OK: REPLACE DOOR GLASS RUN