Programming and Relearning

PRECAUTION

NOTE: When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected.

System Name
Front Power Seat Control System
Combination Meter

PRECAUTION OF HEADLAMP BULB REPLACEMENT

a. When any defect such as deformation, cracks, dents, chipping, etc.is identified on the discharge headlamp (especially, on the lamp control ECU), replace it with a new one.
b. Even if the operation seems to be normal, the fail-safe function may be defective.
c. Since bulbs of the discharge headlamp and halogen bulbs (for headlamps and fog lamps) have pressurized gas inside and can easily be broken if scratched or dropped, special care should be taken. When handling the bulb, hold the plastic or metal part and do not touch the glass part with bare hands.
d. Never touch the high voltage socket of the discharge headlamp with the headlamp dimmer switch ON, as this could generate 20,000 V and lead to a serious accident.
e. Never connect a tester to the high voltage socket of the discharge headlamp for measurement, as this leads to a serious accident because of high voltage.
f. When performing operation related to the discharge headlamp, keep it away from water such as rain, turn off the lamp control switch, and disconnect the cable from the negative (-) battery terminal and the connector of the lamp control ECU in advance to avoid electric shock.
g. When performing operation related to the discharge headlamp, start it after assembling has been completely over and never lamp up without a bulb installed.
h. Do not illuminate the discharge headlamp using another power source except vehicle's.