Torque Specification

Torque Specification Table - Starting & Charging

Part tightened	N.m	kgf.cm	ft.lbf
Starter
Terminal 30 nut, Terminal C nut x Terminal bolt	17	173	13
End cover x Magnetic switch housing	3.6	37	32 in..lbf
End cover x Brush holder	3.8	39	34 in..lbf
Starter housing x Magnetic switch	9.3	95	82 in..lbf
End cover with starter yoke x Starter housing	9.3	95	82 in..lbf
Lead wire of starter yoke x Terminal C	5.9	60	52 in..lbf
Starter assy x Cylinder block	39	398	29
Starter cable x Starter assy	9.8	100	87 in..lbf
Throttle body x Intake manifold	18	184	13
Generator
Generator x Cylinder block	39	398	29
Bearing retainer x Drive end frame	2.3	23	20 in..lbf
Generator pulley x Rotor	111	1,132	82
Generator x Cord clip	5.9	60	52 in..lbf
Coil assy x Drive end frame	5.8	59	51 in..lbf
Brush holder assy x Coil assy	1.8	18	16 in..lbf
Rear end cover x Coil assy	4.6	47	41 in..lbf
V-bank cover x V-bank cover bracket	5.0	51	44 in..lbf