Inspection Procedure

1. Active test
   1. Select the active test, and then check that the power window operates.

HINT:

During the active test, the hand-held tester sends signal to the driver side J/B (body ECU) to drive the power window motor. If the power window operates, the power window motor itself and the wire harness between the power window motor and driver side J/B (body ECU) is considered normal.

Standard [Driver side (J/B body ECU) (rear LH side)]: 

OK: GO TO FLOWCHART IN  POWER WINDOW REGULATOR SWITCH CIRCUIT (REAR LH DOOR)  

NG 

1. Replace the power window regulator switch assy rear (LH side).
2. Check the power window operation.

OK: END 

NG: GO TO FLOWCHART IN  POWER WINDOW REGULATOR SWITCH CIRCUIT (REAR LH DOOR)