Inspection Procedure

HINT:

Read freeze frame data using the hand-held tester. Freeze frame data records the engine conditions when a malfunction is detected. When troubleshooting, freeze frame data can help determine if the vehicle was running or stopped, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.

1. CHECK OTHER DTC OUTPUT (IN ADDITION TO DTC P0505) 
   1. Connect the hand-held tester to the DLC3.
   2. Turn the ignition switch to ON and turn the hand-held tester ON.
   3. Select the item: DIAGNOSIS / ENHANCED OBD II / DTC INFO / CURRENT CODES.
   4. Read the DTCs.

      Result: 

      OTHER DTC OUTPUT (IN ADDITION TO DTC P0505)
      
      

      Display (DTC output)	Proceed To
      P0505	A
      P0505 and other DTCs	B

      HINT:

      If any other codes besides P0505 are output, perform troubleshooting for those DTCs first.

   B: GO TO DTC CHART (See  DIAGNOSTIC TROUBLE CODE CHART  ) 

   A: Go to next step. 

2. CHECK CONNECTION OF PCV HOSE 

   NG: REPAIR OR REPLACE PCV HOSE 

   OK: Go to next step. 

3. CHECK AIR INDUCTION SYSTEM 
   1. Check for vacuum leaks in the air induction system.

   NG: REPAIR OR REPLACE AIR INDUCTION SYSTEM 

   OK: Go to next step. 

4. INSPECT THROTTLE W/MOTOR BODY ASSY 
   1. Check the throttle valve condition.

   NG: REPLACE THROTTLE W/MOTOR BODY ASSY 

   OK: REPLACE ECM (See  REPLACEMENT  )