Steering Angle Sensor: Installation

WARNING: This page is about a different car, the 2007 Lexus GX 470. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL STEERING ANGLE SENSOR
1. Install the steering sensor.
  
  Fig 1: Identifying Steering Sensor
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the steering sensor connector.
INSTALL TURN SIGNAL SWITCH ASSEMBLY
INSPECT SPIRAL CABLE (See INSPECTION )
PLACE FRONT WHEELS FACING STRAIGHT AHEAD
INSTALL SPIRAL CABLE (See INSTALLATION )
INSTALL STEERING COLUMN COVER (See INSTALLATION )
INSTALL STEERING WHEEL ASSEMBLY (See INSTALLATION )

Fig 2: Locating Steering Sensor Connector
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL STEERING PAD (See INSTALLATION )
INSTALL STEERING WHEEL COVER LOWER NO. 2
INSTALL STEERING WHEEL COVER LOWER NO. 3
INSPECT SRS WARNING LIGHT
HINT:

(See DIAGNOSIS SYSTEM )
PERFORM STEERING ANGLE SENSOR ZERO POINT CALIBRATION
HINT:

(See CALIBRATION )
CHECK VSC SENSOR SIGNAL
HINT:

(See TEST MODE PROCEDURE )