Inspection Procedure

WARNING: This page is about a different car, the 2007 Lexus GX 470. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Be sure to read DESCRIPTION before performing the following procedures.

CHECK FOR DTC OF OTHER COMPONENTS

Check if the component shown by sub-code is displayed in the check result of the other components.

Check if "01-DC" is output for the other components.

If "01-DC" is output for any other components, check if the same physical address is displayed.

Result

FOR DTC OF OTHER COMPONENTS

Result	Proceed to
"01-DC" is output and the same physical address is displayed	A
"01-DC" is not output or the same physical address is not displayed	B

HINT:

For the list of the components shown by sub-codes, refer to COMPONENT WHICH HAS STORED THIS CODE .

B: Go to step 4

A: Go to Next step

IDENTIFY COMPONENT WHICH HAS STORED THIS CODE

Fig 1: Identifying Display Screen - Service Check Mode (Example)

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Enter the diagnostic mode.
Press the preset switch "2" to change to "Detailed Information Mode".
Identify the component which has stored this code.

Component table

COMPONENT WHICH HAS STORED THIS CODE

Component	Physical address
Stereo component amplifier	440
Television display assembly*	1F6
Radio receiver	190
HINT: *: w/ Rear seat entertainment system "440 (Stereo component amplifier)" is the component which has stored this code. For details of the DTC display, refer to DTC CHECK/CLEAR .

CHECK COMPONENT WHICH HAS STORED THIS CODE

Select the component which has stored this code.

Component table

COMPONENT WHICH HAS STORED THIS CODE

Component	Proceed to
Stereo component amplifier	Stereo component amplifier communication error
Television display assembly*	Television display assembly communication error
Radio receiver	Radio receiver communication error
HINT: *: w/ Rear seat entertainment system

NEXT: END

CLEAR DTC
1. Clear the DTC (See DTC CHECK/CLEAR ).
  HINT:
  
  If "01-DC" is output for only one component, this may not indicate a malfunction.
RECHECK DTC
1. Recheck the DTC and check if the same trouble code occurs again.
  OK: Malfunction disappears.
NG: Go to step 3

OK: END