Transfer Control Solenoid: Installation

WARNING: This page is about a different car, the 2006 Lexus IS 250. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL TRANSFER CONTROL SOLENOID
1. Install the transfer control solenoid and solenoid lock plate to the transfer upper valve body with the bolt.
Fig 1: Installing Solenoid Lock Plate
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Torque: 6.4 N*m (65 kgf*cm, 57 in.*lbf)

HINT:

Install the solenoid lock plate into the cutout on the transfer control solenoid.
INSTALL TRANSFER VALVE BODY ASSEMBLY (See Step 2 in INSTALLATION )
INSTALL TRANSFER OIL PAN (See Step 2 in INSTALLATION )
INSTALL TRANSFER DYNAMIC DAMPER (See Step 3 in INSTALLATION )
INSTALL ENGINE REAR MOUNTING MEMBER (See Step 4 in INSTALLATION )
INSTALL FRONT NO. 1 FLOOR HEAT INSULATOR (See Step 3 in INSTALLATION )
INSTALL FRONT EXHAUST PIPE ASSEMBLY (See Step 4 in INSTALLATION )
INSTALL HEATED OXYGEN SENSOR (See Step 5 or 6 in INSTALLATION )
INSTALL FRONT CENTER FLOOR BRACE (See Step 7 in INSTALLATION )
INSTALL REAR NO. 1 FLOOR PANEL BRACE (See Step 8 in INSTALLATION )
ADD AUTOMATIC TRANSMISSION FLUID (See AUTOMATIC TRANSMISSION (A760H) or AUTOMATIC TRANSMISSION (A960E) )
CHECK FOR EXHAUST GAS LEAKS