Transfer Wire: Inspection
WARNING: This page is about a different car, the 2006 Lexus IS 250. However, it is still accessible from the selected car via links, so may be relevant.
- INSPECT TRANSFER WIRE
- Disconnect the transfer wire connector.
- Measure the resistance according to the value(s) in RESISTANCE SPECIFIED CONDITION TABLE .
Standard resistance
RESISTANCE SPECIFIED CONDITION TABLE
| Tester Connection | Specified Condition |
|---|---|
| i1-1 - i1-2 | 5.0 to 5.5 ohms |
| i1-1 - Body ground | 1 M ohms or higher |
| i1-2 - Body ground | 1 M ohms or higher |
If the resistance is not specified, replace the transfer wire.