Height Control Sensor Sub-ASSY Rear LH: Replacement

HINT:

• Use the same procedures for the RH side and LH side.
• The procedures listed below are for the LH side.

1. REMOVE HEIGHT CONTROL SENSOR SUB-ASSY REAR LH
   1. Disconnect the connector.
   2. Place matchmarks on the height control sensor link and bracket.
   3. Remove the nut and disconnect the height control sensor link.
      Fig 1: Removing Nut And Disconnecting Height Control Sensor Link

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   4. Remove the 2 bolts and height control sensor sub-assy rear LH.
      Fig 2: Removing 2 Bolts And Height Control Sensor Sub-Assy Rear LH

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. INSTALL HEIGHT CONTROL SENSOR SUB-ASSY REAR LH 
   1. Install the height control sensor sub-assy rear LH with 2 bolts.
      1. Torque: 7.8 N.m (80 kgf.cm, 69 in.lbf) 
      Fig 3: Installing Height Control Sensor Sub-Assy Rear LH With 2 Bolts

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   2. Align the matchmarks on the height control sensor link and bracket.
   3. Install the nut.
      1. Torque: 5.4 N.m (55 kgf.cm, 48 in.lbf) 
   4. Connect the connector.
   Fig 4: Installing Nut

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. ADJUST VEHICLE HEIGHT (SEE ON-VEHICLE INSPECTION  )