System Outline

Vibration Seat Operation 

If the vibration SW on the START side is turned to ON when the ignition SW is on, the signal is sent to the vibration seat ECU through the rear seat ECU. And the vibration seat ECU vibrates the vibrator at about 30 Hz. If the vibration SW on the start side is kept being depressed, the vibration increases to about 60 Hz. Then it decreases to about 1Hz and increases again.

The strength of vibration can be adjusted at will. However, the operation will halt under the following conditions:

* When the vibration SW on the STOP side is turned to ON.

* When the ignition SW is turned to OFF

* When the manual operation of the power seat (Rear passenger's seat) is performed.

* When the vibration SW on the STOP side is not turned to ON even after 30 minutes from the operation.