Height Control Valve Sub-ASSY No.2: Replacement

REMOVE HEIGHT CONTROL VALVE SUB-ASSY NO.2
1. Disconnect the connector.
2. Disconnect the 3 air tubes (see PRECAUTION ).
3. Remove the 2 nuts and height control valve sub-assy No.2.
  
  Fig 1: Removing 2 Nuts And Height Control Valve Sub-Assy No.2
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL HEIGHT CONTROL VALVE SUB-ASSY NO.2
1. Install the height control valve sub-assy No.2 with 2 nuts.
  1. Torque: 5.4 N.m (55 kgf.cm, 48 in.lbf)
2. Connect the 3 air tubes (see PRECAUTION ).
3. Connect the connector.
INSPECT AIR LEAK (SEE ON-VEHICLE INSPECTION )

Fig 2: Installing Height Control Valve Sub-Assy No.2 With 2 Nuts
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002