How To Proceed With Troubleshooting

HINT:

• Using these procedures to troubleshoot the vehicle stability control system.
• *: Use intelligent tester.

1. VEHICLE BROUGHT TO WORKSHOP 
2. INSPECT BATTERY VOLTAGE 

   Standard voltage: 11 to 14 V 

   If the voltage is below 11 V, recharge the battery before proceeding.

3. CHECK COMMUNICATION FUNCTION OF LARGE-SCALE BODY MULTIPLEX COMMUNICATION SYSTEM (BEAN) 
   1. Use the intelligent tester to check if the Multiplex Communication System (MPX) is functioning normally.

   Result 

   RESULT REFERENCE
   
   

   Result	Proceed to
   MPX DTC is not output	A
   MPX DTC is output	B

   B : Go to MULTIPLEX COMMUNICATION SYSTEM 

   A : Go To Next Step 

4. CHECK COMMUNICATION FUNCTION OF CONTROLLER AREA NETWORK (CAN)* 
   1. Use the intelligent tester to check for normal functioning of the CAN communication system.
      1. Perform bus check (communication malfunction DTC).

   Result 

   RESULT REFERENCE
   
   

   Result	Proceed to
   DTC is not output	A
   DTC is output	B

   B : Go to CAN COMMUNICATION SYSTEM 

   A : Go To Next Step 

5. CHECK FOR DTC* 
   1. Check for DTC and note any codes that are output.
   2. Delete the DTC.
   3. Recheck for DTC. Try to prompt the DTC by simulating the original activity that the DTC suggests.

   Result 

   RESULT REFERENCE
   
   

   Result	Proceed to
   If DTC does not reoccur	A
   If DTC is reoccurs	B

   B : Go to step  7

   A : Go To Next Step 

6. PROBLEM SYMPTOMS TABLE 

   Result 

   RESULT REFERENCE
   
   

   Result	Proceed to
   Fault is not listed in problem symptoms table	A
   Fault is listed in problem symptoms table	B

   B : Go to step  8

   A : Go To Next Step 

7. SYMPTOM SIMULATION 
8. OVERALL ANALYSIS AND TROUBLESHOOTING 
   1. Terminals of ECU (TERMINALS OF ECU  ).
   2. DATA LIST/ ACTIVE TEST (DATA LIST / ACTIVE TEST  ).
9. REPAIR OR REPLACE 
10. CONFIRMATION TEST* 

    END