Crankshaft Position Sensor: Removal

REMOVE ENGINE UNDER COVER NO.1 (See REMOVAL )
REMOVE FRONT FENDER SPLASH SHIELD SUBASSEMBLY RH
1. Remove the screw, and then open the front fender splash shield sub-assembly RH.
  
  Fig 1: Identifying Screw, And Front Fender Splash Shield Sub-Assembly RH
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE FRONT FENDER APRON SEAL RH
1. Remove the clip and 2 bolts, and then remove the front fender apron seal RH.
  
  Fig 2: Identifying Clip And Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE CRANKSHAFT POSITION SENSOR
1. Disconnect the crankshaft position sensor connector.
2. Remove the bolt, and then remove the crankshaft position sensor.
  
  Fig 3: Identifying Crankshaft Position Sensor And Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002